Quote from: kerney666 on September 06, 2019, 03:51:49 PM

Quote from: pepe000 on September 06, 2019, 10:24:41 AM

Quote from: ku4eto on September 06, 2019, 05:45:48 AM

Quote from: pepe000 on September 05, 2019, 11:15:19 PM

Quote from: kerney666 on September 05, 2019, 08:13:52 PM

Quote from: pepe000 on September 05, 2019, 02:41:30 PM

I get error when starting TRM on cnr algo
- Failed to initialize device idx 5 (-31)

Well, I can't say you overdid it providing details about your setup Grin

.

The error is a buffer allocation error, so I'm guessing you're running win10 and have too little swap available to support >= 6 cards? If so, is it possible to increase it to at least >= 48GB?

Another wild guess is that your 6th is a smaller gpu, but you have specified a cn_config that tries to allocate more scratchpads than the gpu can support.

48GB did the job, but i am getting around 800 h/s on each rx 570 x 6 (1250/2100mhz)

You know, Ethash timings are not the same as CN timings.

I know, i have timings as recommended from TRM for rx570 8gb

I'm guessing you are running 570 8GBs with Hynix mem, the most problematic Polaris gpu to get good CN perf out of.

Do you know what mem type you have? If I'm correct, check this recent post by a fellow user: https://bitcointalk.org/index.php?topic=5059817.msg52275435#msg52275435, using those straps should give you a nice little bump at least and maybe hit 950 h/s or so.

Yup, it`s Hynix mem
Thank You all for the reply