Quote from: BRADLEYPLOOF on February 20, 2014, 07:55:52 PM

Quote from: Sp00n1980 on February 20, 2014, 07:53:19 PM

Quote from: MikyMouse on February 20, 2014, 06:54:58 PM

Quote from: Mixim on February 20, 2014, 06:46:41 PM

Quote from: Sp00n1980 on February 20, 2014, 03:04:20 PM

wow very impressive Cool

hope you dont mind me asking a few questions Grin

are you running that off the raspberry pi in the lower picture? and if so how are you configuring the USB? (something like PI>>un-powered hub>>powered hubs/ants?)

also did you have to do the resistor swaps to get the speed above 2Gh/s?

and did you have to direct wire the hubs? and chance of a link to the info or pic Grin

thanks in advance Grin

Yes, its running on/with raspberry. I not configured USB, I used the Minepeon-Image and only updated bfgminer on 3.10.0. So far I not touched resistors. The Hubs are connected through a fifth HUB with 4 ports with usual USB-Cables, Power-Connection for HUBs I soldered directly on the HUB-Boards on the original Power-Connector.

Can i ask why you soldered the wires instead of use the original connectors?

also where did you solder too?, i have been googling and i cannot find a guide or and pics etc Sad

https://docs.google.com/file/d/0B-_jcpU1s5dgVWtKeFAwWVlfZlk/edit

This is the PDF of the U1 help. Solder to the highlighted areas. The 10K (upper) resistor is empty, so just solder in a new one. The other one (just below it) needs to be removed then resoldered. Everything is surface mounted.

sorry i was re-fairing to the hubs Grin