Quote from: suchnoob on February 24, 2014, 10:05:07 PM

Quote from: peterd on February 24, 2014, 09:47:22 PM

Quote from: Cloudpost on February 24, 2014, 07:09:29 PM

Quote from: werum on February 24, 2014, 07:03:59 PM

agree, no information
all rejected

Mine solo until there will be pools! Open wallet, close it. Put .conf in your appdata coin folder, edit solo-miner.bat (downlad and unpack miner) by adding your username/pass (from .comf file) and gpu settings. Start wallet again, wait until it syncs and start solo-miner.bat. If your best shares parameter changes means you're solominig successfully!

Pools are not ready but will be ready soon!

This is what I did. however all I got was a no-suitable longpool message and lots of share below target messages. Before I did this I was unable to start the miner at all. My best shares is changing(up to 6.35K now) however I have a feeling I'm still doing something wrong. My solo bat file:

thorcoinminer -o 127.0.0.1:29551 -u enterusername -p enterpassword --scrypt --Nfmin 4 --Nfmax 30 --StartT 1393167677 -I 15 -g 2 --thread-concurrency 8000 --temp-target 70 --auto-fan --gpu-vddc 1.100 --gpu-memclock 1350 --gpu-engine 945

What gpus do you have?
change that to
-g 1 --thread-concurrency 8192 or 30592 depends on your gpu

Using a 6950. I normally run most scrypt mining at -g 2