Quote from: estacionsj on May 03, 2020, 05:02:50 AM

Quote from: ManaMatt on May 03, 2020, 04:26:53 AM

Quote from: estacionsj on May 03, 2020, 03:15:04 AM

So today i final got my node package from futurbit, i put in the micro sd card, put in all my info set it up and started mining, waited 2 hours to make sure it all worked fine.so after that i plugged in the usb in the back of the Apollo, reset the Apollo from the dash board .Now 15 minutes past and i look at the node dash board an i get this error
There is a problem fetching system stats (Invalid params, response status code: 500)

what did i do wrong or how can i fix it, i thought buy buying the kit it would be all nice and good..... Sad

I also had this bug, refresh your page to "root menu" (the basic ip of your Apollo) and go back to the node, or just be patient, it'll refresh alone (it could take several minutes). you have to sync the blocks, it could take long time sometimes.
But basically, even if it take times (it's no an Asus with i9 and 64Go Ram Cheesy

) Apollo will do the job. If you have this bug, it's that you're not too far to reach the end ;-)

okay, thanks
i will wait going to sleep and see how it goes in the morning

i had this as well - you after you put in the usb - do not just restart it on the dashboard - turn the Apollo off and then turn it on the miner needs to power up with the usb in it. do not start the node from the dashboard unless you stopped it via dashboard - if you power cycle the miner the node should start. it might be unresponsive for a few after powering up but it should be fine.