Quote from: Icebjerg on March 01, 2014, 04:42:04 PM

I'm having issues setting up the wifi to the antminer. I have factory reset the unit twice, and followed the set up exact both times.
I have a wifi antenna attached also. I also have 3 other ants running wifi, it's just the new on I received yesterday that's no working.

Plugged in Ethernet loged in 192.168.1.99
Changed Wan to DHCP
Save and apply, Reboot

Log into 192.168.1.8
Selected network tab, scan, and this is what it reads,

97%    Neighbors
Channel: 1 | Mode: Master | BSSID: 00:18:E7:E6:3E:24 | Encryption: mixed WPA/WPA2 - PSK

Click Join, enter wpa, change network name to Neighbors, Submit
Then it goes to general setup

    [Signal: 0 dBm / Noise: 0 dBm]
0%    Mode: Unknown | SSID: Neighbors
BSSID: 00:18:E7:E6:3E:24 | Encryption: -
Channel: 11 (0.000 GHz) | Tx-Power: 0 dBm
Signal: 0 dBm | Noise: 0 dBm
Bitrate: 0.0 Mbit/s | Country: US

Click save and apply
Then I reboot without Ethernet cable, and no wifi

Miner runs great with Ethernet,

Any help would be greatly appreciated,

Thank you,

So I had the same issue, I got it working.

My issues were two fold, I had entered the wrong password and under advanced settings the mode was set to G+N. I've had issues with wireless N in the past so I killed N by setting it to Wireless-G only.
Instantly everything worked.