Quote from: Tegija on March 01, 2014, 08:14:04 PM

Quote from: smoothrunnings on March 01, 2014, 07:32:47 PM

Have a look at my node; http://p2pool.smoothrunnings.ca:9332/

My local hardware is which the top one is not showing any shares, it was even doing that before it took it down for a while today; I had another issue both with my bicoind (bitcoin-qt) and my own wallet; that issue is I transferred just over 1/2 a bitcoin out and it got stuck. So after a week it according to my personal wallet started to get peers (3 of 6 now), yet on my node it still shows 0 confirmations. Anyhow even after putting my node back up and its been a few hours the miner on the bottom which is running from a different location is getting shares.

The difference here is that the two inside miners have been updated to cgminer 4.0.1 while the outside miner uses 3.9.0 I wonder if the 4.0.1 cgminer is causing the "no shares yet" issue, if it's an issue?

What do you think?

Thanks,

now your node shows 2 shares. considering your uptime it is ok. both shares are probably made by your miner 1JiWFoe6QaE7N6mv2HBkjr4izuDX3cqDQQ. little patience and i think all will be ok.
it can be that both miners made one share and because you have 50%fee one of the shares is going to your node wallet. as you can see your node is "earning" more than your miners.
as far i cold notice there is no differences which version cgminer you have, results are practically equal. my miner with 4.0.1 work fine and i don´t see any difference to miners with 3.9.0.

okay I will wait a bit longer to see what happen, but it used to never to this, both miners always showed predicted payouts. On a different note the p2pool-note-status static page has been updated, it now shows the "payout if block were found now".