Hello, thanks for answering, which configuration and drivers do you recommend to install? I use Etherminer pool, I have the last PMiner, i installed the 20.4.2 drivers but it does not work well either, the first continuous in 0mhs, and by the way I am underperforming. at 11mhs
No CUDA driver found
OpenCL driver version: 20.4.1-2
Available GPUs for mining:
GPU1: Radeon RX 570 Series (pcie 1), OpenCL 2.0, 4 GB VRAM, 32 CUs
GPU2: Radeon RX 570 Series (pcie 3), OpenCL 2.0, 4 GB VRAM, 32 CUs
GPU3: Radeon RX 570 Series (pcie 4), OpenCL 2.0, 4 GB VRAM, 32 CUs
GPU4: Radeon RX 570 Series (pcie 6), OpenCL 2.0, 4 GB VRAM, 32 CUs
GPU5: Radeon RX 570 Series (pcie 8), OpenCL 2.0, 4 GB VRAM, 32 CUs
Eth speed: 46.361 MH/s, shares: 1/0/0, time: 0:01
GPUs: 1: 0.000 MH/s (0) 2: 11.588 MH/s (0) 3: 11.599 MH/s (0) 4: 11.620 MH/s (0) 5: 11.554 MH/s (1)
GPU1: 33C 85% 5W, GPU2: 46C 85% 88W, GPU3: 45C 85% 90W, GPU4: 45C 85% 88W, GPU5: 44C 85% 89W
GPUs power: 359.4 W
Drivers 20.4.2 is normal. You can use them.
What command line you're using? What command line you used for CM? PM supports most of CM options. Press "Z" key after launching for autotune the -gt parameter. It use about 5-10 minutes.