Quote from: br2459 on August 19, 2020, 12:36:01 AM

Quote from: ipp2 on August 19, 2020, 12:21:43 AM

As a stupid dumb quick solution for 4gb cards if you did not mod your bios...

Run claymore v15 and after it applies the straps just right click on the cmd bar and hit edit -> mark. This will pause the program. Your timings and straps are applied.

Now go run say....phx miner with basically no settings except your pool since the GPU settings are done and you can continue mining for a bit until you have time to mod your bios/linux etc.

GL!

That is an interesting question. It will depend on if the DAG has been loaded or not. If that DAG is loaded with CM than it won't load for Phoenix since the memory is already in use. The only way to find out for sure is to try it out..

In Win10 it won’t load DAG since it says not enough memory, cards hanging, restart miner etc.
Simple -wd 0 stops Claymore from restarting.
I tried that and it’s working.
Actually I needed -rxboost from Claymore for another job for two cards from rig.
That’s how I found out about it.

It’s really working in Win10 with any other miner or aplication where you need higher mem speeds

Just tried that edit -> mark thing and it’s also working..