Quote from: CryptoRobert on Today at 09:10:34 AM

Quote from: Gtx1070rig on Today at 04:30:48 AM

Quote from: CryptoRobert on September 02, 2020, 06:49:16 PM

Quote from: Gtx1070rig on September 02, 2020, 03:27:41 PM

Quote from: CryptoRobert on September 01, 2020, 10:49:58 PM

Glad to see the new wallet release. It looks good. Now the main question is: where can I find instructions for building BTX masternodes inside the new wallet?

https://www.reddit.com/r/bitcore_btx/comments/fv9b8a/bitcore_masternode_guide/

just replace with new version (https://github.com/LIMXTEC/BitCore/releases/download/0.90.9.6/bitcore-x86_64-linux-gnu_no-wallet.tar.gz)

Thanks but this is Linux and I'm on Windows - the VPS section is not clear for Windows - and since now there is the Windows version of the new wallet I'd expect it to work on windows - does the MN not work without a VPS? When I try to start the MN I con't go beyond the "PRE_ENABLED" status of the MN.

At least you need a static ipv4 address...
You wanna run ur node at home? Then you need also a device with less power like a raspberry pi or something...
On a gaming/working pc its not worth running...

My PC is running all the time since I'm using it most of the time anyway and I'm staking other coins as well - so that's not an issue. As for the static IP I can use a VPN and that will make it static. Still, why can't I get over the status of "PRE_ENABLED" MN?

the bitcored -daemon not working on windows so just using qt wallet for the node will maybe not working... but i am not sure... i am using raspberry pi 4 at home with linux and its working... from time to time need to change ip... thats all...

It turns out that the profitability calculator is not correct?

[/quote]

the calculator is calculating with old algo/network.... so it cant be correct....

networkhasrate is now about 1.03 MH/s