Quote from: mikxxy on Today at 11:27:23 AM

Quote from: mikeywith on Today at 03:47:07 AM

Take it easy, we all have lost many gears, the failure rate on these 17 series is much more than you can imagine, I would have been more than happy if I got 6 months of all my 17 series gears, so you are not in the worst situation one can be.

Recap:

1- I assume the T17 is done with and you are going to try and solder the heatsinks?
2- You have 2*T17+ , one is fine another one has a bad control board, when you try them on a working control board you get the errors you posted in the last post? is that the case or am I missing something?

If I am on the right track, you should know that mixing hash boards from different miners will cause many issues, so while you are trying to fix all this please keep track of the different hash boards and to which control board they belong.

Status is now 1-T17 about to solder the poped heat sink, the other 2 cards seem to work ok! But before it used to drop another board after been mining for a wihle. So there migth be another bad soldered Heat sink missbehaving when heating up a bit, standing i the farm?. Been knocking around with a pen, I ordered a fixture, so we will see.
2-T17+ the original 'dead one', is now working fine, after it received' a working control board
3- T17+ (the control board donor) Seem to have 2 boards working ok, and the third one not startng due to problem with pic processor. i'll will try to change around hash board cables to isolate problem. The control board came from the 'dead' T17+, so i migth have some issues. It came up with a connection error last night, so i'll check if it remains.

Update
After identifying a bad ribbon cable the other T17+ also works fully, the connection issue was becuase of some instability caused by the faulty hashboard connection!