Quote from: Gpumanijak on Today at 11:33:54 PM

Quote from: miner29 on Today at 09:58:12 PM

Quote from: Gpumanijak on Today at 07:51:31 PM

Guys i have problem i have 4*rx 470 4gb, and one 390 8gb... When i want to turn on team red miner i cannot only because of 390 i Get error, can i stop detection of this card and use only other four...

From the link on the First Post of this thread:

-d, --devices=DEVLIST Sets gpu devices to use from detected list. DEVLIST should be a comma-
separated list of device indices, e.g. -d 0,1,2,4. If not specified, all
devices on the platform(s) will be used. NOTE: by default the devices are ordered
by pcie bus ordering. Use --list_devices to show indices.

I did that and same, i got error, When start recognizing he said dont recognize hawaii and just reset miner...

If the 390 is not in 1st position gpu0...does it work on the 1 card with -d 0
This should only allow it to run on that card. Then add one by one until you work it out.
You can also do the list_devices to see the numbering. Because it sounds like you are not omitting the card. Also try both -d and —devices=