Quote from: geck on Today at 08:10:06 PM

Quote from: Seph213 on December 23, 2020, 11:14:25 PM

Quote from: jelome198959 on December 23, 2020, 11:43:11 AM

Quote from: Seph213 on December 23, 2020, 04:00:09 AM

Quote from: philipma1957 on December 23, 2020, 02:51:21 AM

Pull the back plate and fan the fuck out of it?

And void my warranty for 10mh ? Not very appealing . Right now i’m just pist i got the gaming trio cause prior to buying general consensus was that these cards were safe from issues .

Should of went for an evga ftw3 or the asus tuf . I’ve always seen good results from evga’s when it comes to OC for mining .

I'm curious.

So, to be clear:
1.) GPU-Z doesn't indicate it's thermal throttling.
2.) Setting the fan on auto --- what fan speeds do you get?
3.) Can't unlock voltage monitoring
4.) What MSI AB version are you running?
5.) Nvidia driver version?

1.) i’m using hwinfo and its not showing me thermal temp limit reach. It does show me power limit reached tho. Not sure how to see thermal throttling with gpu-z . I’ll look at it if u show me where to check

2.) fan is set to auto. Temp is at 45-48c with fan usually being around 60-70% . Just added some 120mm magnetic corsair fan so inside the case is very cool. Oh and i have a fan outside my case right in front of the card to push out any hot air.

3-4.) i downloaded the MSI AB 4.6.3 beta and was able to have the core volt enable but even with that maxed out the card still throttles .

5.) nvidia driver 460.89 the latest .

1)In GPU-Z look for PerfCap Reason. It should say Idle when you are mining, and will change the Therm if it is thermal throttling.
3-4) do not raise core clock or core voltage, it just exacerbates the problem.
If you use MSI AB you need to underclock and undervolt using voltage curve mode (I have mine flattened to 1000mhz, this will cause the gpu to run at its lowest voltage possible, thus lowering PL without reducing hashrate). Press ctrl+F when you are using MSI AB. Do not underclock by setting PL.

In GPUZ Perfcap season is pwr while mining . I did notice that at 300mem or lower it says idle . Soon as i go above that it changes to pwr .

I tried to set the curve at 1000mhz but everytime i apply , it goes automatically to 1300mhz . I tried 1100 but same thing .