Quote from: scotjam on March 12, 2014, 01:35:29 AM

Quote from: phatchance on March 04, 2014, 01:44:04 AM

hey guys, got my miner today, i had my pi setup and ready
im at the stage now of entering the command
"./autogen.sh enable-avalon"

after following these instructions: https://www.asic-hardware.com/assembly-instructions-part-2/

but each time it gets the the 3rd or 4th chip im guessing its trying to configure it keeps failing, may there be a problem with the board or is anyone able to point me in thr giht direction?

here is where it is failing:

i have tried updating the firmware, deleting cg miner and re installing it to try and re build but nothing seems to be working

any help or suggestions would be much appreciated

phatchance.

Isn't it "--enable-avalon" rather than "-enable-avalon" (i.e. two hyphens at the start rather than one?)

scotjam

It is --enable-avalon, got stuck too..thx a lot