Quote from: Yottabyte on March 17, 2014, 03:29:31 PM

Quote from: wolfey2014 on March 17, 2014, 03:05:46 PM

Quote from: Yottabyte on March 17, 2014, 02:58:30 PM

Quote from: wolfey2014 on March 17, 2014, 02:43:04 PM

Quote from: Yottabyte on March 17, 2014, 01:22:10 PM

Is there a method for viewing real time hashspeed in windows? right now I'm using CPU miner as depicted in this guide, it is working and my pool is reporting approximately the hashrate I would expect, but it would be great to be able to see real time speed, so I could tweak/troubleshoot the devices when needed. If not in Windows, I could switch over to Xubuntu on my laptop and control the devices from there, if there is a way in linux...

Right now I have 3 devices (more arriving today), they are powered by a Corsair CX500 PSU, all 3 running off one PCIe 6pin plug. I have to say that right now they are pulling way more than the "8 watts" advertised in single mode scrypt... My Kill-aWatt meter is reading 170 watts at the wall for the 3 pack (psu plugged into meter). Also, I have these running at 800 right now. At 850 I noticed some nonce errors, and a lower hash speed reported by the pool... and oddly enough, at 850 the units were pulling LESS wattage, about 120watts as opposed to 170 @ 800. And finally, thanks to those who put work into this guide, it's been real helpful!

Use this. No hassles!

http://cryptomining-blog.com/?s=Download+cpuminer+for+Gridseed+5-chip+GC3355+ASICs+with+Reduced+Power+Usage

Each GS5 will run at no more than 7 Watts in Scrypt Only mode! Usually less!

Enjoy!
Wolfey2014

Hmm... I feel like I'm getting on track here...

There is reference to a "LTC_ONLY.bat" file, where is can I find that file?...

Also... are there any known drawbacks to using a WiFi connection for these setups?

Always happy to help a fellow miner.

Hmm, well, I know one can make their own bat file and simply start each minerd action that way.
Is this what you're referring to?

Wolfey2014

One of the steps was: "- Download, edit and run LTC_ONLY.bat file from the modified cgminer 3.7.2 for Gridseed ASICs to start mining for LTC"... but I saw no download link... im not sure how to create a .bat from scratch for these, would you happen to have a working .bat file I could view as a reference?

That's just a pitch to the unwary to sucker them into using cgminer. IMO, cgminer and bfdminer are still too much of a pain in the ars to use because they are line code intensive and you have to learn coding, albeit a somewhat higher language than assembly. Still, so much to memorise. Check the threads on them. You'll find tons of config errors, troubleshooting and very few are actually running stably with them, without having to babysit them.

Skip all that mess and just use cpuminer if you want to get up and running in minutes instead of hours ,,, or years Cheesy

!!!

Scrap that other stuff and use this,, only... http://cryptomining-blog.com/?s=Download+cpuminer+for+Gridseed+5-chip+GC3355+ASICs+with+Reduced+Power+Usage

Good luck!
Wolfey2014