Quote from: varakunai on March 19, 2014, 07:55:48 PM

Quote from: JointDoctor on March 19, 2014, 07:43:45 PM

Quote from: xjack on March 19, 2014, 07:37:17 PM

Quote from: JointDoctor on March 19, 2014, 07:34:10 PM

Quote from: xjack on March 19, 2014, 07:27:47 PM

Quote from: JointDoctor on March 19, 2014, 06:34:54 PM

Quote from: gallery2000 on March 19, 2014, 06:20:19 PM

Thank you! Did you lose any dragons while tweaking them?

No units, but 2 blades.
...and you´re welcome guys

Any luck getting single blades to replace them?

From the photos I'm seeing around, it looks like the mining controller will handle 6 blades, so if there's a way to get extras that might be helpful to those of us who will be receiving 32-chip miners.

The 32 chip version is 4 blades. The MCU can handle 8 units, only ports for 6, together with the pi.
I don´t know how the manufacturer handle warranty for you guys but i´m a bulk buyer so i get extra blades to avoid expensive RMA shipping (My deal says that the vendor is responsible for all shipping cost when it comes to RMA and warranty). Grin

I wasn't thinking warranty, I was thinking more along the lines of buying another card or two and upping the power to get 1.2-1.4 TH/s.

Fully doable, just connect the blade/blades to the MCU and power (If you got the 2x650w version just plug in PCI-E connector/connectors) and lay it/them down on the plexi glas area. Runs a little bit hotter then the other blades, like 2-3 degrees. 32 chip version + extra blade/blades = Adjust clock setting to 850Mhz to be on the safe side.

I want to order 8 more blades to put into the 4 machines i ordered to give me a total of 6 per unit. Anyone know if we can order the blade separately?

Cheshyr is getting stonewalled by the vendor, sounds like they want to sell whole units only. Maybe one of the other resellers or bulk buyers?