Quote from: nullama on Today at 12:02:32 AM

Quote from: n0nce on August 21, 2022, 02:25:22 PM

~snip~
As long as they're 3-pin fans, they will plug straight into the hub's fan output - that will run them at full speed. To run at roughly half speed (5V instead of 12V) you can solder them to the end of a USB cable and plug them into USB. But you could also use a Noctua low-noise adapter instead, that is usually shipped with them.

Keep in mind if they're 4-pin, you will need a PWM fan controller of any kind.

Noctua has its own PWM fan controller, and it's awesome. The NA-FC1, it works really well. You can connect multiple fans to it, runs off 12V, you can control the fans either with a PWM signal or by hand turning the knob, and it takes very little space:

I know, I already recommended it! Wink

Quote from: n0nce on August 21, 2022, 01:10:04 PM

you could get a Noctua NA-FC1, 4-Pin PWM Fan Controller