Quote from: ssimbaa on April 10, 2014, 09:57:27 AM

Quote from: opieum2 on April 10, 2014, 02:58:30 AM

Quote from: AMT_miners on April 10, 2014, 02:42:39 AM

Quote from: NotFuzzyWarm on April 09, 2014, 11:41:21 PM

Do these have a web interface aside from an IP setup, and pool/password menus? Would be nice. (Ants do). All kinds of info including network traffic is available. Also allows for all the usual 'ux type shells, system maint., & other goodies.

Yes, but the rigs do not come with the little LCD display because they are mounted to the hard drive trey in the case - mounted either with electrical tape or double sided mounting tape. Also we've seen the little LCD screen flop from side to side because of length of the connector cable, and have shorted the rasPI a few times when the screen accidentally hits the RasPI because the screens sides are all metal. That's the main reason we do not include the screen in the Kit, it's frustrating to get the screen to sit properly on the table and is generally an accident waiting to happen. The only purpose of the the little LCD display is to show the ip address of the user interface and the current hashrate.

Upon going to the IP address in your browser (Don't bother with internet explorer, use any other browser) you will see the user interface.

Accessing the user interface:

Username: admin
Password: admin

Accessing the ip address without the little LCD screen:

Plug an HDMI cable into the rasPI and start the miner by plugging in the cable. You'll see a big raspberry with a loading bar on the bottom. After which you'll see the root login:

Access cgminer of AMT 1.2Th miner:

username: root
pass: amt

#killall cgminer (the miner is programmed to start immediately, that's why we kill cgminer upon login, as a rule the miner starts running with the credentials you add in the cgminer settings page (Click Settings - then click Cgminer)

#ifconfig

You'll see several addresses, the first being a local network ip address, usually starting with 192.168.1.(some number here) or 10.1.10.(some number here). Use that address to find the user interface in your browser.

If you don't have an HDMI cable and monitor free, you can check your router's admin panel for new ip addresses detected after plugging in the network cable and plugging in the miner.

Remember: From the time you plug in your miner, your miner is mining, so make sure all your fans are running and proper cooling is administered. A1 chips heat up quick, and you do not want to over heat your miner.

Workaround encase you don't want to start mining immediately and want to test the Raspberry pi and user interface setup first:

Unplug the GPIO ribbon cable from the back plane before plugging in the network cable and starting the miner. Login to the rasPI with the credential above and get the IP address first, then go to the Ip address in your browser, configure your settings (pool settings, speed, etc) and save. Then power off the miner, plug in the GPIO ribbon cable to the back plane, connect the backplane to the hashing modules - (make sure all the pins from the back plane connectors are in the right slots - look above and below each pin/connector on each module - plugging in the backplane wrong can short hashing modules which may result in the miner not seeing the module.) Then power on your miner and you should be good to go via the user interface or ssh login.

More to come on that for sure, but that was a quick response with a bit more details for those that receive their kit encase we don't get a video up within the next few days.

OH and what Linux distro is this using? I had hoped to set up powerstat on there for power monitoring on the machine itself.

Does the DIY kit include a Raspberry PI ?

yes it does. im using one now from kit i got this morning