Quote from: peruana on April 18, 2014, 08:27:07 PM

Quote from: dalenorman2005 on April 18, 2014, 04:15:09 PM

Several people seem to be concluding that their power supplies are "dead" or malfunctioning based on them refusing to turn on for several minutes after turning the S2 off. FYI, all three of my batch 1 S2's act this way - when you turn one of them off, you have to wait at least 10 minutes (haven't timed it, but it's more than 5 minutes and less than 20 minutes...) before they will agree to turn back on again. disconnecting power cord, swearing, etc have all proven ineffective.

I don't think this is a malfunction - i think it must be a design "feature" of this particular power supply. Or perhaps it's the way they are powering off... typically, you would not shut off a server by flipping the switch on it's power supply. you'd issue a shutdown command in the OS and have it gracefully shut the system down. I don't think that is possible with the S2 as the ATX motherboard cable is not utilized. it's really unfortunate that the BBB board was not powered by the ATX motherboard cable - that would have gotten rid of the "paperclip" mod and perhaps made it possible to gracefully power on and off with a soft button the front of the case.

But the way it's designed, when you flip the power supply off while the case is open, i see the system power off then, after about .5 sec, it powers on for just a fraction of a second. a little blip.

Perhaps this blip is causing two problems - corrupts the SD card, and trips something in the power supply that stops it from powering back on for several minutes.

I'm very interested in hearing if replacing the power supply solves the corrupt SD card issue. that would be great!

You can flip the 110/220 switch back and forth while unplugged to reset internal relay

Unplug ac and short circuit with a coin.