Quote from: Z-tight on Today at 04:59:50 PM

BitPay wallet is a custodial wallet, so you can neither set nor customize your fee rate,

Quote from: BoXXoB on Today at 11:53:53 AM

If you rely on a custodial service such as BitPay and they don't let you choose the fee, then there's nothing you can do.

BitPay wallet is non-custodial and gives users full control over their fund.
BitPay doesn't allow users to set the fee rate manually and it's very bad at fee estimating.

At the time I am writing this post, around 120 sat/vbyte is enough to put your transaction less than 1 vMB from the tip of the mempool and below is how BitPay is estimating the required fee rate.

Super Economy: 149 sat/vbyte
Economy: 199 sat/vbyte
Normal: 281 sat/vbyte
Priority: 281 sat/vbyte
Urgent: 421 sat/vbyte

Quote from: PX-Z on Today at 06:07:55 PM

Since you can't import your recovery phrase from bitpay to electrum ( i tried but address are different). So what you can do is to wait until tx fees go down by checking mempool.space then make a transaction to your non-custodial wallet.

To import a seed phrase generated by Bitpay into electrum and get the same addresses, you must use the derivation path m/44h/0h/0h.