Quote from: Jess85 on April 27, 2014, 02:45:48 AM

Quote from: happydaze on April 27, 2014, 02:33:59 AM

Quote from: Jess85 on April 18, 2014, 03:06:43 AM

..................
- Reversible VMOD3 added (Courtesy of ZiG)

Step B) If you want to revert to VMOD1 simply solder together both of the two point sets shown [in Figure 7].
....................

Jess85 - Step B needs clarification as it has merged two separate mods. ZiG's rmod requires that you cut the bridge at R46 then one method is to solder the resistor as described. To reverse ZiG's rmod you would remove the resistor and re-solder the bridge at R46. Then you could do VMOD1 if you want but vmod1 has nothing to do with ZiG's rmod.

I think I may have missed the R46 mention!
But as I understand it, re-soldering the bridge at R46 should be enough to reverse the mod no? having to remove the axial resistor would then defeat the claim that it is any more reversible then the original VMOD3 I would think. At least that's what was personally understood from reading ZiG's earlier posts.

Can you please clarify on this?

Yep...Happydaze is right...R46 needs to be cut first...

Reversal is as easy as shorting back R46...or the Rmod...the additional resistor on R46 pads...you can do this with a wire on the Rmod terminals...without even removing it...

So no other Mods are involved / needed...

If you have questions...Let me know...I like your guide and will be happy to help you improving it...

ZiG