I found that sometimes AN3 just won't let itself set to 'High' even after running om 'high' for a while it turns out it has suddenly has thrown itself offline I then notice it's mining on 'Low' ...
If that's the case (ie. AN3 going by itself form 'High' to 'Low') there's no way to get it back to 'High' but to either pull powercord **) or using  'AvalonNano3RecoveryPackage' complete reset to get it to go to 'High.'

For me the Avalon Nano 3 is a very unstable device that I'm even starting to think I wouldn't reccomend to a friend... but I'll keep running it one more week to see if the problems persist after having changed pool now


It's been a tiresome battle using the AN3 since I got it about a week ago. For me it's been very unstable:

Logs off intermittently /throwing itself 'off' the net for whatever reason, suddenly not mining on 'High' 

The worst thing is the pain that comes with the fact that every change in setup that needs a reboot: BUT: Doing a reboot the AN3 then demands that I go through 'First time setup'  again - every time!!!  - because it can't re-connect to same net previous setup by me  

Even after no errors  tha action of just turning it 'Off' it refuses to connect to last used network by itself after reboot. No way, never done it once even.

But at same time the AN3 can run for +18 to 24 hrs without any errors (aot this tells me it's not the PU (USAMS 140W USB-C 3.1) causing errors) Temp is 50/90 *C =pretty normal


(**: which leads to having to go through setup again because it't won't reconnect back to previous setup wifi

Love to hear from other ppl if this rings a bell !