Quote from: unpainted on Today at 08:50:22 AM

Quote from: BlazingSwamps2 on Today at 08:36:10 AM

Would anyone lay down a schema of the pins? there are 6 and not sure which one to use.

The pins are labeled on the back of the board, see the picture in the top left corner.

https://www.talkimg.com/images/2025/02/06/eJTxJ.th.jpeg

Connect the ground of the adapter to the GND of the ESP pin. Then connect adapter TX with P_RX and adapter RX with P_TX crosswise.

To make the ESP32 flashable, you must switch to boot mode: Connect GPIO0 (IO0 on the LV07) on the ESP32 to ground (GND on the LV07). Then press the reset button on the back of the LV07 with a paper clip. Only then disconnect the ground from GPIO0.

Thank you so much.