Ninjastic
PostEdited versionsQuotes to this post
Next scheduled rescrape ... never
Version 1
Last scraped
Edited on 20/05/2025, 09:06:51 UTC
Quote from: CMMPro on May 19, 2025, 10:55:45 PM
Ok hold on...I disassembled the unit, and reseated the 6 heatsink screws, and all seems to be ok.

The two vregs came back to full power.

Don't ask me why since they don't ground or somehow function other than to hold the board to the heatsink...but it seems to be better and hashing at 4.5th now.  

I don't like fixes that don't have a measurable value, or reason why, but its working again.
https://www.donsn.idv.tw/VR.png
Let me answer the previous question about the order first. I think the order is U1, U2, U4 (the part circled in red)

I also found a similar problemproblems! When installing the large heat sink is mounted, it will be very close to the three capacitors (the red boxes), so I used high -temperature insulating tape to separate them before locking them.
Original archived Re: Lucky Miner LV08 - Firmware
Scraped on 20/05/2025, 08:36:56 UTC
Quote from: CMMPro on May 19, 2025, 10:55:45 PM
Ok hold on...I disassembled the unit, and reseated the 6 heatsink screws, and all seems to be ok.

The two vregs came back to full power.

Don't ask me why since they don't ground or somehow function other than to hold the board to the heatsink...but it seems to be better and hashing at 4.5th now. 

I don't like fixes that don't have a measurable value, or reason why, but its working again.

I also found a similar problem! When installing the large heat sink, it will be very close to the three capacitors, so I used high-temperature insulating tape to separate them before locking them.