Quote from: aumusxou on May 05, 2014, 03:09:23 AM

Quote from: x8008 on May 05, 2014, 02:02:52 AM

Quote from: arbitrage001 on May 05, 2014, 01:57:57 AM

G-glade hash rate fluctuate wildly and going down a few times a day.

yes I get this issue a lot as well, please fix this especially for those who rent out on leaserigs

Using worker difficulty 16, 32 and 64 make the blade very unstable (too many errors force reboot apparently). The blades are much more stable with something like 1024 difficulty. I think the problem lies with pools that don't allow you to set the miner difficulty, or don't use VARDIFF properly. So set a higher worker difficulty, or use a good pool with VARDIFF.

If it were possible to change the error tolerance for reboot, that would be great. I don't know if that's hard-programmed into the controller, or if GAW can allow us to set a limit. There seems to be something with the blade that causes errors and reboots when getting lots of small work very fast, versus less, higher-difficulty work.

Power issues:(?)
There have been several times when my blades will get stuck in a reboot loop, even at higher work difficulties. I've emailed support, and they say, "It was a power issue", and usually the blade comes back online, apparently after they tweaked something. Other times, 1/2 of the blade is down, while the other half is just fine. Rebooting only makes that good half come back up again, while the other half is still down. This happens often. Eventually (hours), the other half comes back up.

Not sure if GAW has fully implemented their "revamping of the blade's power delivery for all effected blades", or if it is just selectively done. I'm guessing all of the blades suffer from lack of proper available power, and that GAW hasn't updated the power delivery for every blade- just those that people have complained about. This guess is from the observation that others also are still having issues, and that I get 1/2 of blades that won't come back up after reboots, or blades that won't reboot.

It's possible this is due to poor blade design, or the controller. It would be nice to know that GAW has upgraded the power delivery for EVERY blade, so that this can be ruled out, and not just for "those blades effected by a power delivery issue". I think I still may have power delivery issues on some of my blades, manifested as reboot loops, or half the blade staying stuck.

Anyone else seeing the "1/2 stuck blades", or infinite reboot loops?

100% Agree. See the same issues in my UI. From support I heard they are working hard on the issues. A statement today would be great the LOOP of Restarting is a real problem cause it takes sometimes 1-2 hours.