Quote from: dyland on May 08, 2014, 07:46:52 PM

Quote from: wolfey2014 on May 08, 2014, 07:39:05 PM

Quote from: dyland on May 08, 2014, 05:32:35 PM

Quote from: Ferris419 on April 30, 2014, 02:09:21 AM

Quote from: dyland on April 30, 2014, 01:32:51 AM

Quote from: poopypants on April 29, 2014, 08:37:11 PM

Quote from: dyland on April 29, 2014, 08:34:57 PM

will this mod work with hashra controla?

The mod will work for any mining software, you just need to change the chip frequency.

Nervous to attempt, but an extra 100 khsh across 20 miners translates to an extra 2Mhsh. Anyone want to share any best practices aside from OP?

I did the 49.9k mod on all 14 of my gridseeds and I'm glad I did. I'm running CPUminer and all of my chips are stable at 1200mhz and up. The pool and CPUminer and both reporting very close to each other so I'm happy!!

I am having no luck with my 20 modded units running hashra controla on rasp pi. after volt mod, my pool reports almost half of my un-modded previous hashrate Sad

are you on rasp pi or windows for cpuminer?

I am looking for a plug and play solution for raspberry pi that will work with the 47.7k volt mod.

any ideas from anyone?

Controlla may be the culprit. I can't say how optimized it was/is for use with volt modded pods.
Try CPU miner. It's the one virtually all of us cpuminer lovers are having the most success with, locally and pool side.
I'm mining on suchpool for and their hashrate states vary radically sometimes but usually they are very close to what my local pool rate says.
Nice work Sandorino!
Yep, Wolfey finally took the dive and has been running .09f for a couple hours now. So far so good! Wink

By the way, do you have a list posted of all the new/latest features and commands. I know, it's on github, right? Wink

Tanks!

Crap. I wouldn't have gone down this route if I had known hashra controlla wouldn't work as I have zero time. Literally. I have to time the end of my pee with flushing the toilet so I can have an extra two minutes per day of sleep.

This is why I asked if it would work in the first place.....

Anyway, I have not the first clue about where to get cpu miner, how to load it, etc. Once I were to image it onto an SD, would it be plug and play into the rasp pi?

Thanks in advance for your help.

OR, would anyone in this thread be willing to sell me a plg and play SD for my Pi that will work with 20 volt modded pis?

Please, don't panic. I could be way off on this! Hashra might just be fine and something else is causing your problems.
I'm not a Controlla user so I have the same problem you do 'how to use' and experience with wise. Chill out! Cheesy

Please ask for Sandor111's help or perhaps HappyDaze can chime in on this too? I know there are other 'experienced' Controlla users out there too!

Don't worry, you'll get it sorted out.

Peace