Quote from: quakefiend420 on May 18, 2014, 05:43:05 AM

Quote from: Jess85 on May 18, 2014, 05:32:12 AM

Quote from: quakefiend420 on May 18, 2014, 05:17:04 AM

I seem to have found something else, too. If I have more than 10 blades connected the GUI fails to display, says that the miner isn't running. But I can SSH into it and check the screen output from minerd to see that's not the case.

Anyone else running more than 10 devices on this distro?

I can confirm this. In fact if you try to run more than 10 blades many issues begin.

Most recently after I did a fresh image flash to an SD and turned up my raz for the first time to input pool info for mining I got a:
Warning!
I can't get the stats from your minerd. Please try to refresh the page or check your settings (minerd API must listen on 127.0.0.1:4028).

in the dashboard.

stats.json:
{"error":true}

Log shows:
[2014-05-18 05:22:35.2043] API: Client 127.0.0.1 connected

[2014-05-18 05:22:35.3127] API: Client 127.0.0.1 connected

[2014-05-18 05:22:35.4424] API: GET: stats

many times over but other than mining for 10 whole blades (pool confirms this) still nothing. I also tried forcing api port to via parameter but still nothing.

Another more critical issue is that it will not mine on more than 10 G-Blades (roughly 20 blade boards) at a time. This is a super critical problem because it has forced me to run all blades on 3 raspberry pi's (plus no stats reading =/)

I actually only have 6 total units running so far, 12 individual boards. It seems to be behaving ok so far, just the missing stats. I haven't tried to figure out a manual API call yet to see if it's minera or cpuminer that's at fault.

Hi,

I can confirm this. I got 25 Blades aka 50 Boards running and they work like a charm with a wheezy / cgminer image. If I load the minera image + run the update it I see the exact same. After around 30min several blades go off. I tried to install Minera manual on a computer with more power to see if that might be the issue but it is behaving the same.