Quote from: SavageWS6 on May 29, 2014, 07:21:00 AM

Quote from: marklin on May 29, 2014, 07:18:01 AM

Quote from: SavageWS6 on May 29, 2014, 07:11:14 AM

Quote from: marklin on May 29, 2014, 06:56:06 AM

Quote from: SavageWS6 on May 29, 2014, 06:47:51 AM

Quote from: marklin on May 29, 2014, 06:34:37 AM

6970 6950 5870 Why so much hw! Have you got any solution!
Cry

What is your current configuration right now? can't help without knowing your config

"intensity" : "18,18,18,18",
"xintensity" : "0,0,0,0",
"rawintensity" : "0,0,0,0",
"worksize" : "128,128,128,128",
"kernel" : "x13mod,x13mod,x13mod,x13mod",
"lookup-gap" : "0,0,0,0",
"thread-concurrency" : "0,0,0,0",
"shaders" : "0,0,0,0",
"gpu-threads" : "4,4,4,4",
"gpu-engine" : "0-0,0-0,0-0,0-0",
"gpu-fan" : "0-85,0-85,0-85,0-85",
"gpu-memclock" : "0,0,0,0",
"gpu-memdiff" : "0,0,0,0",
"gpu-powertune" : "0,0,0,0",
"gpu-vddc" : "0.000,0.000,0.000,0.000",
"temp-cutoff" : "95,95,95,95",
"temp-overheat" : "85,85,85,85",
"temp-target" : "75,75,75,75",
"api-mcast-port" : "4028",
windows 7 64 amd 14.6

Damn your config is a hot mess. What did you get this at? Like I don't even know where to start.

You can't use intensity,xintensity, and rawintensity.. It doesn't work like that, Just choose one. I don't know what a good number is for your cards

Your look up gap needs to be set to 2.

set your gpu-threads to 2

Your setting your GPU engine to 0 Mhz.. Well not actually but its messed up. Either remove that flag or set the clocks via Sapphire TRIXX or MSI Afterburner. Same thing for gpu-memclock and gpu-vddc.

Set your temps a lot lower. temp-target is fine at 75, temp over-heat I'd say 80, and cut off at 85... but on this kernel it doesn't even get that hot. You also need to set your fan speed via software or in your configuration. Look at my post- https://bitcointalk.org/index.php?topic=623409.msg7008775#msg7008775

That config isn't for your card but it will give you a idea what it should look like. Also downgrade your drivers to 13.12, you'll thank me later

Heat and frequency are no problem! I use marucoin this parameter can be run and there is no hw
With 13.12 driver is ok?

Ya 13.12 will be fine. 14.4 and 14.6 are very finicky atm with mining. I'd just avoid them till another driver comes out or just in general avoid it

Or not! I don't know why! I try to modify the XI and RI but I don't know how to change!
"Xintensity
rawintensity
The two values