Quote from: Dehumanizer on June 09, 2014, 11:43:36 AM

Quote from: platinum4 on June 09, 2014, 11:41:09 AM

Quote from: Dehumanizer on June 09, 2014, 11:39:14 AM

I was just trying to use the auto-switching but it doesn't seem to work for me. When I set pool ports to 33xx, everything works perfectly, I can manually switch pools and all pools work, however when I switch it over to 43xx and start the sgminer, it says that all pools are dead after a while. Any suggestions?

Perfectly normal; in order to 'switch' only one algorithm can be 'selected' at a time. All of NH ports that start with 43xx are multi-algo ports, which will shut, so when 1 is selected, the other 4 algos go dead. If you have no failovers, it is possible you may get no work served if there are not enough orders up for that algo.

I understand that, but there surely IS some work at least for scrypt, since when I go manual, it works. So it's unlikely that there's no work for any algo...

There is no 'at least'. And there are no multi-algo pools.
There are pools with different algos which go offline/dead if they are not profitable.

So you must configure all 4xxx pools for nicehash in order to get this to work.
Tho, check nicehash thread, apparently they ban by IP for 'hacking'..