Quote from: QuiveringGibbage on June 15, 2014, 10:07:48 PM

Quote from: SVK on June 15, 2014, 05:36:16 PM

Your last picture is showing temps. Which one is XSPC and which one is H100 ?

Readings at the time of posting.

Code:

0: HFB JOLOKIA : 725MHz 83C 100% 0.86V | 661.5G / 551.2Gh/s WU:7700.2/m A:4392305 R:4814 HW:1084
1: HFB FRUTESCE: 725MHz 71C 100% 0.87V | 471.7G / 547.7Gh/s WU:7652.2/m A:4367387 R:8278 HW:1210

JOLOKIA @ 83C is the Corsair H100i, with fan mods (2 x 1amp, ~150cmf server fans)
FRUTESCENS @ 71C is the XSPC Raystorm Kit. (with only 2 of the 3 server fans going atm)

The model of the server fans' Sunon - PMD1212PTB1-A(2).F.GN

Ambient temps out side the room is 10C atm and windows wide open. I need to new battery for the thermometer in the room. I'd say it's high 20s C if not 30C in the room.

Still slowly increasing the clocks and voltages. Was too rush before and had odd results. Taking my time now..

I did reapply the Thermal paste and re-attached the water heads to the Habanero boards. Swapped them over the 2nd time to see if there's much difference in the boards. No noticeable difference in performance after I switched the water heads on the boards. I assume both board are preforming relatively the same on stock settings.

Next up is making a fan attachment to the frame so I can attached fans to blow over the boards. Should have this done when the 2nd water head arrives in the next few days.

Cheers,
QG

Many thanks

Are you running both boards from that AX1200 PSU ?
If yes there might be your problem.
I'm using 2 PSUs 850W + 750W and power draw from the wall is around 1450W at 775MHZ.