Quote from: despoiler on February 21, 2012, 05:47:44 PM

Quote from: Tim the Magician on February 19, 2012, 02:55:03 AM

Quote from: Photon939 on February 19, 2012, 12:18:55 AM

All you have to do is pop up the fan hub and apply oil directly to the fan shaft

I did apply some force to attempt to pop the hub off but it got to the point where it felt like it would break and I went the hole drilling path.. Can you give a little more detail? I have 9 of these cards so I expect I'll be doing this again at some point.

Thanks,
Tim

I posted a video how on the previous page.

https://bitcointalk.org/index.php?topic=18111.msg685005#msg685005

Quote from: abracadabra on February 19, 2012, 10:38:59 AM

I would not try to "pop up the fan hub" as Photon939 says. I tried and broke the fan. You are trying to get lubricant to the shaft. That's the reason for drilling 2-3mm off center. I beleive at 8mm you are way too far from the shaft and you now risk drilling into the armature of the motor. If you nick an armature wire, motor is done. I showed Tri-Flow but I believe any teflon based aerosol spray will do the trick. I wasn't worried about the spray being "too energetic" I want some lubricant getting in there. After running them overnight, hit them with another couple short bursts. Forget about trying to reinstall the same sticker. It'll eventually fall off unless you clean off the fan hub nicely and apply new adhesive.

You are a gorilla then. I did this with no issues following the video's instructions.

We are discussing a non-reference fan.

Sincerely,

The Gorilla.