Quote from: proclivity on July 11, 2014, 08:00:19 PM

Also Elenelen reports it can take some time to load so give it a few minutes. Worst case, use putty to login and edit the VRM config file manually then reboot.
If you can't bring up the advanced tab try clearing browser cache.

I managed to get the advanced page; I think you have to initiate it by clicking that tab but it never wants to load the first time after restart. So to get advanced tab just flick to it and then to something else before going back to advanced tab.

Quote from: Tigggger on July 11, 2014, 05:33:11 PM

Lots of errors are usually accompanied by the affected die showing it's not running with 0v 0a on the advanced page.

Yes, 0A and 0v for those two DC/DC.

Quote from: Tigggger on July 11, 2014, 05:33:11 PM

I've had that a few times as I have been tweaking the voltages and speeds to get the best out of mine.

I can't even get that one running at 50Mhz.

Quote from: Tigggger on July 11, 2014, 05:33:11 PM

When it happens a 'reboot' won't usually fix it, so I would give the affected die more volts and/or drop the speed, apply the settings then physically power off the miner, most times it then comes back to life

Thanks for the tip, but no joy.

Quote from: raskul on July 11, 2014, 05:34:33 PM

how many TH you was? 3TH/s?

2.9... KnC still haven't delivered a 3TH machine or a refund.

Quote from: proclivity on July 11, 2014, 08:00:19 PM

1.1.x is ASIC 2 die 2, increase the V on that die. As Tiggger said that's an indication that the die/VRMs have turned off.

What is safe voltage to increase to?

u27