Quote from: ckolivas on July 18, 2014, 03:21:10 AM

Quote from: Grayson5 on July 18, 2014, 03:18:55 AM

Making some progress with the Terraminer. I hooked up both boards directly to my PC, installed WinUSB, and then started up version 4.3.5 using the --ps-load 80 parameter since I used to run it at power step 8.

Cgminer recognizes the boards and they get an initial hash rate of about 200g for a second on each board and the over about a minute it goes down to 0.

I get a constant output of checksum bad for each board.

The miner registers on my pool for about 2 minutes and then nothing

Is there a parameter I am missing?

Any suggestions?

Sorry try 4.3.4 as 4.3.5 had the checksum code which is for newer firmware.

I'm sure its what you think it is but if thats avalon chip in that terraminer the one time I saw that was a technobit using its software in a multi coin site (switch pool).

Just make sure that doesn't end up being the reason.

In other news I'd hope they put a check in place for version control like drillbit so you either lock the older device out or use an older code function. I was still in hope newer devices would have a push so they get firmware update on load like my cable card device.