Quote from: bitfor8888 on July 25, 2014, 02:56:38 AM

Quote from: bitfor8888 on July 24, 2014, 12:27:37 AM

Got mine yesterday. One work fine at 449G per pool stat., but the other one is not working Sad

.

Half of the ASIC was xxxxx. I tried to change psu, cable, shutdown the one working and switch to this one (in case my new RM1000 is not working or not have capacity), reset it, change ethernet cable. I even change the place 20 km apart! Nothing work.

I did show it got all 3 workers alive and the first one even get work (but discard them all). Pool stat. said it was touched in 11 hours ago but not lately. I double check the tailoring is the same (DHCP etc.) and hence it might not be mine.

(I did open the case see whether there is any thermal paste. Nothing. Hence not for that reason.)

Have to get back to Bitman for maintenance. A bit disappointed. 6 S1 since April is all fine and hence may have too high expectation on its working.

Solved by install the firmware to get the "failover" menu (which the shipped one menu does not have it). Did install 2 times as the first time preserve the settings does not work. They are both 430G+. Cheers!

Can you explain what the failover drop down does? It uses the other miner as a controller or something?