Quote from: allcoinminer on August 07, 2014, 06:05:32 AM

Quote from: jokillerftw on August 07, 2014, 01:57:58 AM

hi 1 of my s3s are not connecting right to the network or the pool . because the light is an consistent red . not blinking or green . just stable red How do i fix this. What does this mean.

Connect one S3 and shutoff all the other ones connected to your router/switch/modem.
Go to Antminer S3 web interface via your S3 ip address.
Do a firmware update and when its finished shutdown your Ant S3 then, shutdown your computer, modem/router/switch, etc.
Now start the Antminer S3, start modem/router/switch, then, start computer.
Login again to Ant S3 web interface and put your pool details on miner configuration page.
Save and Apply and wait for 5 minutes then look whether its working now.

If not working go to your WAN page, do the below.
Correct your default gateway in S3, you can look at your computer default gateway if your computer is connected to the same modem/router/switch or use the ip address of the modem/router/switch your Ant S3 is connected to.
Replace the already existing DNS entry with 4.2.2.2 and add another DNS entry and put 8.8.8.8 there.
Save and Apply. Wait for 5 minutes and check whether its working.

If not working go to the Diagnostic Page ( Network->Diagnostic tab ) click on the ping button.
when ping is completed take a screenshot of the below pages and post them back here.

1. S3 Diagnostic Page
2. S3 WAN Page
3. S3 Miner Stats Page
4. S3 Log Page"s"
5. WAN/INTERNET stats page of your modem or router connected.
6. Go to your computer connected to the same router/modem/switch/wifi your S3 is connected and go to command prompt, enter ipconfig /all and take a screenshot of it and post here.

PS: Hide your Public IP address from all your images. IP address can be found by google "MY IP".

I did what Allcoinminer suggested and which i a very gratfull for helping me out going this struggle. After i set up the 2 DNS entries i just gave a resset on machine (touched the resset buton for about 2 or 3 seconds) and then i reconected the machine, changed to my desired ip and in the middle of this i gave it also a reboot and it started working properly. I found this very strange as the previous batches were like plug and play no need to make this kind of changes.