Post
Topic
Board Pools (Altcoins)
Re: [ANN][AUTO-SWITCH] Profit-switch auto-exchange pool: CleverMining.com
by
swiftshoot
on 13/08/2014, 05:01:43 UTC
Anybody else showing lower hashrate on Clevermining than on their miners? My miners show an average hash rate of about 7.2 Mh/s with only about 1% rejected shares, but Clevermining is only showing an average hashrate of 4.2 Mh/s.

I'm running 20 Gridseed 300+ Kh/s miners at 850 Mhz off of an ASUS EeePC laptop (I couldn't get my Raspberry Pi to run stably).

To what my controller says (mining software) and Clever, I typically see about 20-15% variance. I typically focus on the 24 averages. 

This is the 24 hour average. I haven't had any problems with Clevermining previously.

Yes I have seen lower mining due to the following issues:

1: Clevermining.com "Pool 0 is issuing work for an old block: "  When it does this, the miners sit idle can take up to 5 minutes each old block.
2: Hiding block content from us as well.

I was looking for a point of contact to report these problems but there is no address where we can inform them of this bad issue.  Basically my miners are performing 20-30% lower than they should be.

Clevermining.com can you please look into the problems above?
Clevermining.com admins... can you respond on this issue?