Quote from: swiftshoot on August 13, 2014, 05:01:43 AM

Quote from: swiftshoot on August 12, 2014, 03:32:05 PM

Quote from: pwnate on August 11, 2014, 03:55:25 AM

Quote from: geemang on August 10, 2014, 09:36:23 PM

Quote from: pwnate on August 09, 2014, 09:08:59 PM

Anybody else showing lower hashrate on Clevermining than on their miners? My miners show an average hash rate of about 7.2 Mh/s with only about 1% rejected shares, but Clevermining is only showing an average hashrate of 4.2 Mh/s.

I'm running 20 Gridseed 300+ Kh/s miners at 850 Mhz off of an ASUS EeePC laptop (I couldn't get my Raspberry Pi to run stably).

To what my controller says (mining software) and Clever, I typically see about 20-15% variance. I typically focus on the 24 averages.

This is the 24 hour average. I haven't had any problems with Clevermining previously.

Yes I have seen lower mining due to the following issues:

1: Clevermining.com "Pool 0 is issuing work for an old block: " When it does this, the miners sit idle can take up to 5 minutes each old block.
2: Hiding block content from us as well.

I was looking for a point of contact to report these problems but there is no address where we can inform them of this bad issue. Basically my miners are performing 20-30% lower than they should be.

Clevermining.com can you please look into the problems above?

Clevermining.com admins... can you respond on this issue?

Anyone can help on this issue about getting old blocks on mining and making the miners go idle?