Quote from: Koontas on August 20, 2014, 04:01:11 AM

Quote from: bjalbert on August 20, 2014, 03:43:56 AM

Quote from: Koontas on August 20, 2014, 03:40:57 AM

Just updated to the 0811 firmware and there is no longer anything displaying under "Frequency" and the miners are hashing at less than 100gh/s... Any ideas?

(Apologies if this was covered somewhere in this long ass thread)

When you flash uncheck save settings and it will fix the problem. there may be other ways but that is what I did.

Thank you.

The other way is to select the Miner Configuration tab then select the NEW Advance Settings tab where you have a pull-down to select your frequency, the default is 218.75. Once you select the default or the frequency you were running before select the Save & Apply in the bottom right hand section of the window and you should be good to go. Most if not all of them went to 100GH/s after the update.