Quote from: BakSAj on September 12, 2014, 06:10:31 AM

Quote from: alpatcomm on September 12, 2014, 12:28:09 AM

Hi Emdje,

I know this is a really newb question. But what ip address is the new firmware set at? Only asking because my mates placed our internet connection on 192.168.2.... rather than the usual 192.168.1 and am having trouble working out what ip the firmware web interface is set at?

Ive tried 1.125, 1.136, 1.106, 1.163 and im out of guesses now. lol

Any help would be greatly appreciated. Cheers mate

Alex

The OS is set to DHCP. I advise using a port-scanner to find out.

Thnx for the answer BakSAj. I logged into the router and looked at the connected devices to figure out which ip-address the miner had.

Quote from: alpatcomm on September 12, 2014, 08:56:45 AM

Hi guys, Ive setup the new firmware and it seems to be running smooth at 1320mhz, which most people agree on this thread, is a good stable point for each module.

Only question i have is, whats the best setting to place the DEVICE INITIAL DIFF?

Ive set mine at 128 for the moment, but I'd appreciate any feedback/explanation which anyone may have.
For example, what setting is most suitable and what exactly is the 'DEVICE INITIAL DIFF', in the first place?

cheers again guys, appreciate all the help so far.

Alex

Depends on the mined coin. A very 'fast coin' (fast block time) requires a lower difficulty, a 'slow coin' (slow block time) requires a higher difficulty. A lot of pools have automatic difficulty selection. When that is the case you don't really have to do anything.