Quote from: SLok on September 12, 2014, 08:57:40 PM

Quote from: lightfoot on September 12, 2014, 07:11:41 PM

Also what speed is being reported by Eligius? Say the 22 minute numbers, do they match the lower or higher of the 3 BFG numbers?

The pool is kind of the final solution on speed, you're not getting rejects so I'm curious.

22.5 minutes 809.57 Gh/s 254464sh, went for a drink, refreshed the page, and....22.5 minutes 765.59 Gh/s 240640sh, next refresh and the same 22.5 minutes 809.57Gh/s 254464sh again.

I never considered eligius' status page to be accurate, is the 22 min. number any good as a reference? BFGminer low shows 776, mid 807, high 854 and up till 940
BCP both units have the solid on led, that goes on/off when hashing. One has a second led just below the first one, it blinks fast about 6 times (so fast it's impossible to count the actual number), then it goes off for a sec., it does this from powering up, and keeps doing it. There are more leds, just noticed 1 or 2 between the pcb and the copper plate, solid on, I see the reflection on the sledge's base plate under the right chip.

Lightfoot have you tried getting anything by jtag, or is that what you got as said earlier, with chiliflash?

Ognasty, I restart the pc and miners every time I make a change or after a shut down bfgminer, shouldn't be a problem there. The fan on the fets made no change so far, after 6 hours hashing.

edit; no time for the utp now, but I doubt it will change anything.

There are actually 4 lit LEDs under the water block there (7 total LEDs), they indicate good voltages present for 5.0, 3.3, 1.8 and either 1.5/1.2 volts.

As seen from the data you uploaded, you have a board with 'B' chips on it as the engine counts are roughly 800 engines per chip.

There are 64 'tiles' per chip and 16 engines per tile for a total of 1024 engines per chip. I've not run across a pair of chips that have all 1024 running, I think the closest was around 2028.