Quote from: willoneal on September 23, 2014, 09:25:51 PM

Quote from: Swift75 on September 23, 2014, 03:34:14 PM

I have received mine, I had ordered the heat grease and had plenty on hand. 40 x 1.5 gram syringes. I used one for each side of the hash boards.

First inventory parts, I was shorted 2 springs but no big deal I guess.

Next download the latest firmware from bitmaintech.com

Login to miner, and flash the firmware, check the keep settings box

After the upload completes you get a verification screen before it is committed make sure that the information is correct and select Apply/save

wait for the system to reboot login and verify the firmware has taken

if the firmware says its an s3 then the firmware is complete shutdown and tare the Unit apart / clean and prep for assembly.

My first unit took ~ 3 hours but the next was much easier and any additional will be a lot faster

I installed the S3+ upgrade on one of my S1's. I'm holding off on installing the others because my S3+ is mining at 1/2 the speed it did before it was upgraded. It went from 180GHz to 105GHz. (That was using the latest S3 firmware. When I used the latest S1 firmware, no mining is happening at all. Help!

The S3 firmware is only looking for 16 chips, so it will only see half of the chips on the S1 boards.

Try resetting your frequency under the S1 software and then re-boot