Quote from: crazyearner on September 25, 2014, 10:54:56 PM

Quote from: jedimstr on August 15, 2014, 02:14:22 PM

Quote from: NoahWL1 on August 14, 2014, 08:35:18 PM

Sorry if this was already asked, I just couldn't find it anywhere. But here's my question: Are you able to clock the Antminer S1 at a frequency that isn't something like 350, 375, 400, etc. Something in-between those numbers. I recently received an Antminer S1 and had it clocked to 375 because my PSU doesn't have enough watts on the 12 volt rail to go to 400. I want to get the most out of my miner before it becomes non-profitable though, so can I clock it to something like 380 or 390? I think I remember someone doing 389.9 because it ran better than 400, not too sure. Thanks and sorry if this is a stupid question, I'm new to Antminers a bit.

Here you go:

Code:

option 'freq_value' '5f05' #393.75M
option 'chip_freq' '393.75'
option 'timeout' '36'

#option 'freq_value' '5e85' #387.5M
#option 'chip_freq' '387.5'
#option 'timeout' '37'

I have a question regarding the '5f05' What is this value used for as mine is set at 4f81 and clock #400M time out 35 and chip freq 400

The 5f05 is 393MHz chip frequency and somebody calculated that in a normal setting it is the most efficent frequency as HW errors are under 0.1% ... but it all depends on your ambient and how well you have ventilated the device...