Quote from: andytoshi on October 08, 2014, 05:07:03 PM

It's not so much that they are far away from each other (though they are), it's the fact that they can be that hurts parallelizability because you need access to a lot of data. The way to handle this is to maintain an "output set" of all unspent outputs; you add every output for each transaction and delete every output that is referenced in each transaction. Maintaining this data structure (which requires random insert/delete access in roughly equal and enormous proportions, which is a nasty data structure problem ... not sure you can do better than a hashmap) is why you have to go through the song and dance I described.

To see what's involved with verifying the blockchain, you should check out my high level overview and also check out the Bitcoin Wiki pages on transactions and Script. It's a bit involved.

Ahh I see. So I might launch a kernel to verify a block. I would have to pass the block data, along with a pointer to an array of unspent coins in device memory, so that it can do this referencing "[sic]up and down" the chain. The issue is though that the RW bandwidth to the device memory would be massive. You would have to do a lookup on it once per unique address in the blockchain, because at some point all coins are unspent.? (is that correct logic).

To get around this you propose to verify all blocks in parallel, and write any unspent coins for each block into memory. Then do a second pass and verify for each unspent coin that it has some link in the blockchain? Then remove that unspent coin from the list, and if the list is empty after the algorithm runs then the chain is verified?

// I read a lot of the wiki in the past, I need to get back to it. Thanks for the reminder!