Quote from: smoothrunnings on October 08, 2014, 10:19:59 PM

Quote from: Henchman24 on October 08, 2014, 10:00:48 PM

So I have a die that isn't working. Running at ~260 Mh/s max since receiving it.

I read this on the KNC titan support forum:

Quote

1 Test the board individually with different data/power cables. Please also plug the data cable in a different port on the controller board. If this board does not have a die issue when ran individually, it is most likely due to a faulty cable connection, or lack of power from the PSU. If you cannot get the die to switch back on, contact support for more assistance.

I tried all of the recommended steps before emailing support. Not realizing they wanted a screenshot of BFGMiner, I sent them a screenshot of the Advanced screen. A day later Liam responded back that he would need a screenshot of BFGMiner. OK, sent them that.

A day later he responds (paraphrasing) "Oh, I see you're mining at <...> They have problems with the titan. You should switch to one of these pools <...>

Then he closes the ticket.

Riiight, it's the pool causing a die not to work...WTF Angry

It seems if you took the time to read through threads on KNC's own forum you might actually have found out, yes this is the case, and there is a new interesting thread on the subject.

http://forum.kncminer.com/forum/main-category/main-forum/60728-pools-working-with-titan

It seems if you took the time to read my post, you'd see that's not the case. Pool choice does not cause dies to stop working. That's like saying the reason my car's engine is missing on one cylinder is because of the road I'm driving on.