Quote from: RayJay on October 14, 2014, 03:42:38 AM

I used the new firmware with the "Advanced" tab to adjust the clock frequency down to 150mhz, with that the consumption goes down to 240-250w on the wall ( at 310 Gh/s ).
The resistors are located on the back, or the inside where the big sink is attached. You will need to completely remove the board to get proper access to the resistors.
The default value is 2.083 Kohm. And I use the pencil mod to bring the value down to 0.900 to 1.050 Kohm. I have most of mine set close to 0.950 Kohm.
After that the consumption will be down to 180w on the wall ( still at 310 Gh/s ). Noise from the fans and temp will be way down after this mod. And you can use a single PCIE cable to power one S3 ( two hashing boards )

so 180/310 = .58 watts at freq clock 150

if I do advanced tab now at freq clock 200 and 400 gh just a down clock I get 333watts so that is 333/400 = .83 watts

frankly I would be tempted to do this. as I could run 6 s-3 on 1 evga 1300

6 x 180 = 1080 watts and get 1860 gh

could you post photos of the resistor to be pencil modded.

@ neegeeboo

setting for 150 are

#option 'freq_value' '0b83' #150M
#option 'chip_freq' '150'
#option 'timeout' '27' feel free to try 26 or 28