Quote from: kabopar on November 07, 2014, 10:12:20 PM

Quote from: whoami1 on November 07, 2014, 08:56:52 PM

Quote from: mrc_spot on November 07, 2014, 06:31:21 AM

Quote from: whoami1 on November 06, 2014, 07:34:33 PM

Can someone help me?

I became today my Antminer S3.

i give him power and put lan cable insite.

then power on.

the fan works for 1-2 seconds, lan blinking red and green, then fan going out and the LED on the Lan is Blinking RED

i can not go on 196.168.1.99

i can´t see the miner in my fritzbox.

is not working:( what can i do?

I was having same problem with my miner. Your miner is not fully powered up.
Switch of the power supply & turn on after 5m, make sure your power supply is dedicate to this miner (i.e. one power supply for one miner)
Repeat the above step with a gap of 5m until your miner is fully powered up. If you succeed than set the frequency to s3+ default & reboot. Make sure your miner is powered up for 2 days. This will fix the problem, if not than change the power supply. Please let me know if it worked for you.

i try it, but now working Sad

THE PSN has now 530Watt
is a Thermaltake Hamburg 530W

u tell (i.e. one power supply for one miner)

is this only 1 PCI E to 1 Miner ?

and in witch plugin?

if i do 1 insite ( Right site front of Lan ) then the miner start but the lan is not flashing Sad

if i do the 2nd in the left plugin, the miner stops the lan blinking red >_<

You need at least 2 PCI-E power connections per miner, at least 1 on the left and 1 on the right (front/back is less important, but you HAVE to power both left and right sides). If you have 4 PCI-E connectors from your PSU, then use all of them.
Good luck!

If further clarification is needed, look at the picture in section 2 of the manual.

https://bitmaintech.com/files/download/Antminer%20S3%20Manual_EN_2014.7.16.pdf