Quote from: notlist3d on December 04, 2014, 07:43:03 PM

Quote from: opentoe on December 04, 2014, 07:14:09 PM

Quote from: mindtrip on December 04, 2014, 01:03:05 PM

Quote from: opentoe on December 03, 2014, 11:30:00 PM

Quote from: mindtrip on December 02, 2014, 04:34:47 PM

new firmware update posted today one of the changes is increased voltage to 760 This is the fix you all are looking for so I suggest anyone with flaky performance on there C1's do this update. I pushed my voltage up to match the new update and my miner is running even better then it was a 745 volts

I don't get it. I flashed the new firmware and my voltage is still the same as it was before I flashed it. I had mine at 0736. Am I supposed to change it manually to 0740 now or something?

Did you shut off the power on the PSU and then turn it back after you completed the flash?

Yes, I power cycled the units after the flash. Why is this 760 voltage important, couldn't the last firmware you enter 760 as well and reboot it? I also think I checked "save settings" so maybe that was it, but my original question remains. Was the old firmware not compatible with 760 or something or had a maximum?

I updated firmware on mine aswell. Both stayed at the 0725 they were before update. Is the 076 now what is recommended?

Can you please advise us Dogie what is proper setting after update?

If you were fine on 725, you can stay on 725. The 760 default is just to remove the few % of units which needed a tiny bit more juice for all chips.