Quote from: ATCkit on December 15, 2014, 01:46:40 AM

Quote from: ATCkit on December 14, 2014, 04:32:17 PM

I flashed the firmware on all my S3s yesterday to the Nov 24th release (antMiner_S320141126.bin). It created problems like someone else mentioned above.

So i decided to flash them to the October release (antMiner_S320141024.bin). All except one completed the process. It just kept saying flashing for about 30 minutes....like it had stalled.

I tried to re-connect to it using the static address I've been using for 2 months. I got this message: " This webpage is not available".

So i used the reset button and connected it directly to my PC. When I tried to connect to the original IP address (192.168.1.99), I got: "This webpage is not available".

long story short, it seems my computer and router can not see the miner anymore. Also, The green light for the internet connection only comes on for a second after turning on the miner. I also noticed that only the red light blinks. None of the other LED lights come on.

Did the november firmware release (antMiner_S320141126.bin) kill my miner?

Pls help!

EDIT: I also tried using an IP scanner to try to find that miner in case its IP address had changed. The IP scanner showed all my other devices but also reported that there was a dead device.

Anyone got any ideas how to connect to miner that can't be reset?

1. Switch off the troublesome unit.
2. Ensure you do not have any other rig / computer connected to your network with the default IP
3. Switch on the troublesome unit and load the default IP

If that fails, then you have most probably bricked your control board during the reflash.