Quote from: bitsolutions on December 16, 2014, 10:49:37 PM

Quote from: macgyver007 on December 16, 2014, 09:04:14 PM

Quote from: bitsolutions on December 16, 2014, 05:03:30 PM

Sure fire fix assuming hardware is ok and uboot intact is uboot based recovery, interrupt the boot process and set your computers IP to a static IP of 192.168.1.100. Start a TFTP server on your computer serving antMiner_S320141013.bin and run the following commands on your miner.

Code:

tftpboot 0x80000000 antMiner_S320141013.bin
erase 0x9f020000 +0x7c0000
cp.b 0x80000000 0x9f020000 0x7c0000
bootm 0x9f020000

there no need to re-flash the firmware as it is the NVRAM that is corrupt...your suggestion of loading the 20141013.bin will result in being unable to access the config pages as documented in the subsequent release....if anything I would suggest loading the 0826 firmware and then wget the ckolivas cgminer 4.61 but then we are complicating things more than needed...most here seem to have enough problem with putty lets not throw in a tftp server and hex addresses....its a bit of a predicament...0826 firmware with crap cgminer or Russian roulette with the next 3 builds....and all the while BITMAIN leaves the files for MORE people to &$#^&$ their miners up with...well done Roll Eyes

on a different note its nice to see the community working together Grin

SSH in and execute the following to fix webui on the oct 13th firmware.

Code:

sed -i 's/Save\&Apply/Save\&Apply/g' /usr/lib/lua/luci/model/cbi/cgminer/cgminer.lua

To fix config pages after flashing a later release execute this command over SSH.

Code:

cp /overlay/etc/config/cgminer /tmp/cgminer.tmp && cp /overlay/etc/config/network /tmp/network.tmp && rm -r /overlay/* && mkdir /overlay/etc && mkdir /overlay/etc/config && cp /tmp/cgminer.tmp /overlay/etc/config/cgminer && cp /tmp/network.tmp /overlay/etc/config/network && reboot

TFTP recovery is usually required if the OS doesn't boot and you see it stuck bootlooping at uboot.

is this what I need to do?