Quote from: dogie on December 17, 2014, 02:13:12 PM

Quote from: entr04y on December 17, 2014, 01:50:22 PM

Quote from: entr04y on December 16, 2014, 01:14:44 PM

Quote from: entr04y on December 14, 2014, 09:29:06 PM

Quote from: dogie on December 14, 2014, 09:23:05 PM

If its time related then start investigating power related things. The PSU would be the first thing to look at. Try powering only the bad blade pair (as long as they're the ones that power the controller) only and see if they still drop out. Alternatively, you could just swap your PSUs over and see if the problem moves.

Sometimes it happens after five minutes, sometimes it is overnight, sometimes on boot. I'll give swapping the power supplies a try next...

Swapping the power supplies had no effect. I guess I'll see what Bitmain has to say (they got back to me pretty quickly and asked for screenshots, etc), which I've just sent them.

They replied:

Quote

Hi,
Please go to "Miner configuration-->Advanced settings" and increase the voltage to a higher value to try.

Would have been helpful to give me a suggestion... there doesn't seem to be much if any documentation on voltage/frequency settings and I already set it to 0760. Any ideas?

That being said, I haven't had to restart it since yesterday morning.

Single bump -> test. I wouldn't go more than 2 more bumps.

I guess what I'm asking is what are the actual values to enter in the field. It's not a dropdown on my miner and I don't see a list of valid values anywhere...