Quote from: oldjoker on December 22, 2014, 08:29:23 AM

Quote from: oldjoker on December 20, 2014, 12:40:11 PM

Quote from: jackbox on December 20, 2014, 12:11:12 PM

Quote from: oldjoker on December 20, 2014, 12:05:24 PM

Quote from: iglasses on December 20, 2014, 06:51:46 AM

Quote from: oldjoker on December 20, 2014, 06:04:26 AM

Hi
I have a Problem With my Antminer s3
in miner status page i see a 250 GH
and 16 ASIC are work
http://i57.tinypic.com/33os3et.png
PLZ HELP ME

You are missing a chain. Check power supply. Connections. Reboot. If it still is no good try swapping some cables around to isolate where the problem is.

thank you for your help , i check PSU , change PSU , change cable , reset factory ... nothing change

Maybe the cable from the controller board to the hashing board is not on properly. Have you opened it up yet to check internal cables?

no i didn't open the case , ok i'll check it

i opend it up and check internal cables , checked it . nothing found !
one of board's LED is on the other side is off and not work

Have a look at the not working board for dry solder points.

http://upload.wikimedia.org/wikipedia/commons/thumb/2/20/Cold_solder_joint2.jpg/220px-Cold_solder_joint2.jpg http://upload.wikimedia.org/wikipedia/commons/7/72/Gebrochene_loetstellen.jpg